Hey Stan,

When I replaced my signals with led I bought an electronic flasher unit. They are all over the place, Amazon etc. Just buy one with the right number of spade terminals.

Alistair 

> On Aug 25, 2019, at 1:18 PM, Stan Shapiro <mail@stanshapiro.com> wrote:
> 
> 1977 Baywindow, 2 liter, Fuel Injected.
> 
> 
> 
> I installed new LED bulbs for my parking/brake, backup, and turn signals.
> Lighting is MUCH improved.   I even added silver reflective HVAC tape on the
> inside of the light boxes.
> 
> 
> 
> All work well, and the turn signals blink rapidly-as I pretty much  expected
> they would.
> 
> 
> 
> Suggestions on thesamba was to install a 470 ohm resistor to cure the
> rapidly blinking turn signals.      What is the easiest way of doing that??
> I thought about adding a resistor, inline between a male and female spade,
> and then patching that in right at the turn signal.   I am thinking that it
> has to be done on both sides?     Electrical is not my strong point-and I
> may be totally off base, so don't laugh to hard.
> 
> 
> 
> Any suggestions.
> 
> 
> 
> Thanks
> 
> stab